Activitate

HDPE waterproofing membrane products perform a good job of keeping your house dry and tidy, it’s one of the good solutions for leaking houses because it is affordable, it’s low maintenance, and it is very convenient.

It could be a leaking roof or possibly a room leaking one stage further of occupants, it can cause property damage in addition to neighborhoods. This can be a ubiquitous architectural phenomenon, and in construction, leaking water could be the second biggest problem in building quality. Now, a lot of people have got measures, waterproof coatings, waterproof membranes, along with other products.

What exactly are HDPE damp membranes?

HDPE damp membranes are in reality a self-adhesive waterproof material, that has you will of superior performance, hot temperature resistance, and durability. Furthermore, the self-adhesive film includes a polymer adhesive layer.

HDPE damp membranes are made of high-quality high-density polyethylene resin, and at the same time, ultraviolet absorbers, anti-aging agents, etc. are also used.

Features of HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

Easy to construct

Castable skeleton steel bar

It may form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Prepared to walk

As soon as the waterproof layer is done, it could be directly stuck just using the outcome resistance of reinforced concrete with no protective layer

Low requirements to the lower layer, and is constructed on uneven and wet base surfaces

Not suffering from objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Whether it is the rooftop the main ramp, the waterproofing in the tunnel, and also the pool, it can be perfectly waterproofed. At the same time, HDPE damp membranes bring high-requirement waterproof projects and a few gas leakage prevention.

Installation tips

Keep your lower layer clean first. If your sharp area of the protrusion is located, it’s going to be processed to become flat. In case there are more water stains, maintain your base layer moist.

Unroll the membrane. When laying the film for the lower layer, you need to pay attention to the particles with the film facing up, along with the edges of the two adjacent films must be aligned to prevent overlapping.

The way to determine the thickness with the film meets the requirements?

Using this method is extremely brief, take a needle and randomly select 3 points per 100 square meters on the membrane for penetration experiments. Dimensional measurements were created for that thickness with the 3 needle punches respectively, and lastly, an average value was taken for their heights. In the event the average thickness is larger than 1.5mm, it meets the needs.

To read more about màng hdpe go to see this popular net page